Performance Boats Forum banner

1 - 4 of 4 Posts

136 Posts
Discussion Starter · #1 · (Edited)
SOLD. Not running. Motor needs to come out. Motor overheated because of restricted scoop I regretabley installed. Knocking sound inside. Something is broken, we don't know what. Less than 10 hours on blower built motor by Jim Barnard (Barnard Enterprises). No dyno. Estimated at 800 to 900 HP. Tuned at 5 PSI boost. 22 foot single step hull, bottom very nice, top needs a polish, upholstery good, carpet OK. 100 MPH boat. I had it up to 96, but it had more to go. Tons of receipts. Asking what I own. I'm done with boating and don't want to deal with pulling the motor. Located in Ventura, CA. George, 310-408-2032 or [email protected].

Motor information:
Chevy 540 Gen V
8.5 to 1
TBS 871
Howard blower cam, have card
1050 Holley Dominators
Lunati rotating assembly with forged crank
Manley blower piston
MSD crank trigger set a 30 TDC
Quick fuel 230 fuel pump
White performance heads
Teague high volume oil pan
ATI Damper

Drive info:
Bravo One
IMCO Upper
1.23 ratio
Bravo 28P, labbed
Full hydraulic steering stem to stern
Dual ram

Built for this boat by Hoss
Could use paint
All lights work last time used
Tires almost brand new

IMCO fuel tank selector valve
GPS speedo
Dual bilge pumps
Stereo by Speed of Sound in Lake Havasu
Custom Sunbrella snap cover in great condition
Dock lines, anchors, life jackets, etc.


1 - 4 of 4 Posts