Performance Boats Forum banner

Status
Not open for further replies.
1 - 4 of 4 Posts

·
world's oldest teenager
Joined
·
685 Posts
Discussion Starter #1 (Edited)
The Enderle Bird catcher was set up by Enderle for Alcohol on a Blower, has dyno time only on it. I also have a polished tunnel ram manifold (Big Block Chevy) for it, but I am sure it would need to be re jetted for a non blown application.
Pump is and Enderle 110 pump and they just went through it as well. I have two different drives, one is for snout drive by belt, one is for belt drive off the flywheel end, or could also be cam driven. $2,200.00

I also have a Vertex Mag (Chevy) that was gone through by Don Zig a few years ago, but has never been on an engine since. $500.00

Polished Aluminum Belt Guard for a blower, originally from Bergeron Engineering. $175.00
Dave Kahn
818-464-5246






 

·
world's oldest teenager
Joined
·
685 Posts
Discussion Starter #3
Still available, make offer.
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top