Performance Boats Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
61 Posts
Discussion Starter #1
I am blowing out my intake gaskit and my clean out cover after a hard 100 mph pass. where should the pump housing be drilled for a psi gauge and what psi should i be looking for?
 

·
Registered
Joined
·
542 Posts
I spoke with Duane at HTP about this many months ago, I think I remember the correct area. 1-2" in front of the wear ring on the side of the pump. I have a gauge, but haven't gone their yet. I don't know what the pressures should be.
 
1 - 3 of 3 Posts
Top