Performance Boats Forum banner

1 - 3 of 3 Posts

·
Premium Member
Joined
·
400 Posts
Discussion Starter #1
photo-1.JPG this is an mpd made for my gw.it sits at 1/2 below keel right where the pen is.any thoughts on this depth.35 pounds of intake pressure at the top and bottom taps.any thoughts on cutting it like an arrow.thanx in advance
 

·
Registered
Joined
·
3,739 Posts
Rather than trimming your good MPD loader, see if you can loan a loader with the change you want to try before you cut. Loader tuning can be very fruitful if gone about methodically.
 

·
Registered
Joined
·
950 Posts
View attachment 188121 this is an mpd made for my gw.it sits at 1/2 below keel right where the pen is.any thoughts on this depth.35 pounds of intake pressure at the top and bottom taps.any thoughts on cutting it like an arrow.thanx in advance
Mine hangs that low also

I have that exact loader. Pretty much have to trim it back a little and see if you pick up any on your low side.

I know jack has a test loader that is shorter than that maybe he'd let you try first before cutting yours down.

Another thing is not only the ramp length but where the ramps are angled towards the impeller.
 
1 - 3 of 3 Posts
Top