Performance Boats Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
6,278 Posts
Discussion Starter #1
I have a 4-bolt block that is .060 , been decked , line bore checked, O-ringed, Harblocked 1/2 way up, a set of 6.535 Carrillo Rods, & 13-1 J&E pistons. For 4' stroke. No crank.
Were this came from is a friend had an engine built for his bad azz air boat and it didnt make its power low enough in the rpm band so he had a large cid engine built and I bought this setup from him. The pistons , cylinder walls, & stuff only have a few dyno pulls.
This is block, pistons, & rods
$1200

I would prefer local pickup.
 
1 - 2 of 2 Posts
Top