[dekman]

Need help/pics to figure this out......(Sorry couldn't turn it)

 

[Nice Pair]

Need help/pics to figure this out......(Sorry couldn't turn it)

 

[Roaddogg 4040]

Stainless all thread with washers and nuts on both sides. Measure stand off distance "carefully" cut and fit as necessary.:yes:

Steve

 

[dekman]

Thank You......got it!

 

[Dana_Danger]

here you go

 

[Roaddogg 4040]

Thank You......got it!

Don't count without pictures Rob!!!!!!!!!!:duh::wink2:

Steve

 

[dekman]

Thank you Dana...your pic really helps!
Using solid tubes over the all thread really makes it stronger than nuts & washers Stevie.......

(*and maybe someday someone will show me how to rotate these.....)

 

[Sharp Shooter]

I've seen many different variations of blower belt guards and how they mount them. Mine is like this one with the up high mount coming off the blower, then another near the lower middle and I have 1 more on the starboard side. I've even seen guages mounted in these things. )THumbsUp

 

[Roaddogg 4040]

Thank you Dana...your pic really helps!
Using solid tubes over the all thread really makes it stronger than nuts & washers Stevie.......

I was just trying to keeeeeeeeep it SIMPLE for ya Robbie:hmmm::yes:

Steve

 

[dekman]

Thanks for the pic's sharp shooter! Now to mount the drive tube.... Another delay.....need to remove the prop shaft cauz' it needs to be shortened 1.5 " due to the new Whirlaway.....one thing after another :captain:

 

[brockkeenan]

Just going to throw this out there...You may want a hole at the blower snout to run the valves without taking it all apart.