Performance Boats Forum banner
1 - 8 of 8 Posts

·
Registered
Joined
·
2,409 Posts
i will check at my shop tomorrow, i think i just may have one
 

·
Registered
Joined
·
93 Posts
Discussion Starter · #3 ·
i will check at my shop tomorrow, i think i just may have one
thx

thought I already had Glenwood front and rear mounts for Chevy, but turns out I have Debbold. Have one good clamp, one is broken too, and I can't find the other 2. quite the mess I have going :mad:
 

·
Registered
Joined
·
2,409 Posts
heres the front, i will check for the rear one tomorrow.
 

·
Registered
Joined
·
93 Posts
Discussion Starter · #8 ·
clearly I still have a lot to learn about all things v-drive

I made a mistake by posting the original photo at the top of this thread, turns out what I posted is actually a photo of an angle mount setup, I'm looking for a mount that will fit the pin style mount. Photo of my mounts shown below



I might be able to adapt an angle mount plate by building blocks that attach to the pin and bolt to the flat mount plate, but it would need to be a narrow width plate -- the inner width pin to pin is 20.25"

sorry for the wild goose chase, but I have a better understanding of what I'm after now
 
1 - 8 of 8 Posts
Top