Performance Boats Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
1,003 Posts
Discussion Starter · #1 ·
I need the set of 4 spacers for a 10 degree v-drive have some but they were machined down for a thickers mid plate and i bought a new plate and it a 3/8 plate. So i need none machined spacers
 

·
Precision Craft Marine
Joined
·
1,563 Posts
We have them, and thank you Andy. Tell us what gears you have and the type of input shaft, and we can help you. If you are in So Cal, call R B . If you are in Texas, Call JJ. I am sure that one of us can help you. Joe
You can check out our website, but it is under construction. Precisioncraftmarine.com
 

·
Registered
Joined
·
1,003 Posts
Discussion Starter · #4 ·
gears

Im not real sure what shaft this has its out of a 8 second flat how many different shafts are there im going to run 22 gears
 
1 - 4 of 4 Posts
Top