Performance Boats Forum banner

1 - 20 of 39 Posts

·
Some guy
Joined
·
3,636 Posts
Discussion Starter #1 (Edited)
I have an all new 496 shortblock kit, ready to assemble yourself, or I will do it for additional cost.

New Scat forged 4.250" crankshaft
New Scat forged 6.385" H beam rods
New SRP forged pistons (pump gas compression)
New Scat flexplate
New GM harmonic balancer
New Std bearings
New Total Seal Moly rings
Internally balanced
Freshly cleaned, magged, bored and honed 4 bolt block

$2700
 

·
Registered
Joined
·
1,885 Posts
I have an all new 496 shortblock kit, ready to assemble yourself, or I will do it for additional cost.

New Scat forged 4.250" crankshaft
New Scat forged 6.385" H beam rods
New SRP forged pistons (pump gas compression)
New Scat flexplate
New GM harmonic balancer
New Std bearings
New Total Seal Moly rings
Internally balanced
Freshly cleaned, magged, bored and honed 4 bolt block

$2700
What block Dart, GM?
 

·
Registered
Joined
·
1,278 Posts
Barry....
perfect set-up for Steve's boat...stuff a blower on it & whoo weee!!! :) :)

FastRat

p.s. "wish" i had the $$$, i would buy it in a "heartbeat"! :) & stuff my blower set-up on it! :)
 

·
Registered
Joined
·
1,417 Posts
Barry....
perfect set-up for Steve's boat...stuff a blower on it & whoo weee!!! :) :)

FastRat

p.s. "wish" i had the $$$, i would buy it in a "heartbeat"! :) & stuff my blower set-up on it! :)

I don't think my heads will flow enough for that set up, and my cam's too small:|err..... Great price....:)devil
 

·
Registered
Joined
·
1,278 Posts
I don't think my heads will flow enough for that set up, and my cam's too small:|err..... Great price....:)devil
Steve...
my set of heads would "more" than handle that set-up :) & i would get a roller set-up to work & ys, its a "good" price, not a "great" price! (no heads, pan, misc, etc...i have less than that in my complete set-up includeing the blower & misc, etc :)...i still think u should jump on it! :)

FastRat
 

·
Registered
Joined
·
1,417 Posts
Steve...
my set of heads would "more" than handle that set-up :) & i would get a roller set-up to work & ys, its a "good" price, not a "great" price! (no heads, pan, misc, etc...i have less than that in my complete set-up includeing the blower & misc, etc :)...i still think u should jump on it! :)

FastRat

Don't thread jack... Pm me if you wanna discuss something..



Now on with the show:)devil

Bump for a great deal
 
1 - 20 of 39 Posts
Top