Performance Boats Forum banner

Old aka Nostalgic Mickey Thompson M/T 427 Valve covers w/ breathers

2K views 3 replies 2 participants last post by  TTspectra20 
#1 ·
drip castings inside were ground off to clear roller's. definitely could use some polishing. 427 cast in them as well as M/T .. these are not copies and have been on this motor since 1974 and the original owner of my boat said he just threw them on there because the motor needed some and they were sitting around his garage for a few years so they must be pretty old. i think i remember seeing a small spot where one was repaired or the casting was blemished the only time i had them completely off. but i could be wrong and can look again.

anyway $75 sounds fair to me...i'll even throw in the bolts and bitchen oil fill cap! :happy:


Vehicle Car Engine Auto part
 
See less See more
1
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top