Performance Boats Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
5,180 Posts
I used a set awhile back. Also bought some for one of my motors. Have not run mine yet. The other probably has 50 hours and a lot of 6k rpm runs. Holding up so far. Like to hear of any problems for sure.
 

·
Administrator
Joined
·
16,888 Posts
Smith brothers and never look back!!!
I left a rocker loose once and spit the pushrod out and bent it. Called Smith Bros for a replacement and they almost didnt believe I bent one. LOL Said I must have been trying real hard to bend that thing.

Great stuff.
 
Joined
·
1,011 Posts
Discussion Starter #8
Well.....I was going to replace my push rods, so I thought I would up grade at the same time. I decided to take Moneypit and Jocko advice from another thread that was, stop reading and over thinking things. So, I had Comp Cams .080 wall in it that only broke one intake in 10 years. I looked on Comps web site and found they have .135 wall. I got those at .100 longer than I had. Got a good deal on them. Thanks to all who responded.

Tim
 
1 - 8 of 8 Posts
Top