Performance Boats Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
318 Posts
Discussion Starter #1
Ok just like to know what all of you think about SRP Pistons vs Mahle Pistons ?

Which one would you run in a motor ?
 

·
steelcomp was here
Joined
·
26,528 Posts
Been using Mahle in most of my builds. Very pleased with them. The CP is a good piston but I like the Mahle a little better myself, mostly because of their rings that come with the pistons but also an excellent design. We sell Icon, CP/Bulet, Mahle, JE/SRP and Wiseco, so I have no dog in the fight as far as that goes. Of all those, the Mahle is my first choice. I think my second choice would be the Wiseco Pro Tru, but they stopped selling them with rings, so there's a little more cost there. Lots of good "budget" forged pistons on the market.
 

·
Premium Member
Joined
·
25,975 Posts
The down side to CP Bullet is that they are only available in higher compression and flat top. So if your looking for something in a 10 to 1 range for pump gas, its Mahle, SRP, Wiseco Pro Tru, or Icon. If you're thinking about some spray, I tend to lean a little towards the Icon due to the 2618 alloy and they put the ring pack farther down the piston, and shorter, thicker pin. The others in a 10 to or flat top are 3042.

If you not considering any NOS, then I like the Mahle in 10 to 1 range.



100% free webcam site! | Awesome chicks and it is absolutely free! | Watch free live sex cam - easy as 1-2-3
 
1 - 4 of 4 Posts
Top