Performance Boats Forum banner
1 - 2 of 2 Posts

· Aquacraft
Joined
·
755 Posts
Discussion Starter · #1 ·
Hood Automotive tire Vehicle Car Automotive design

Hood Automotive lighting Motor vehicle Trunk Automotive tire

quick question, I have a hall craft steering set up and 2 of the pulleys on the cable tensioner bracket seem like they need to be replaced and I’m wondering where can I get just the pulleys ? I have two small ones that are 2.5 inches and two that are 3.5 inches across, I pressed in new bushing on two of them but the other two seem like the hole that was originally drilled in the pulley was waaay off and drilled crooked no matter how I try to press a new bushing in , it always screws the bushing up and I tried to sand the inside hole of the pulley just to get it straight but if I go anymore I don’t think the new bushing will be tight in the pulley so I’m trying to find a couple of pulleys and haven’t been able to thanks for any help, one of the big pulleys is bad and one of the small pulleys is bad I’m sure I can make it work but if I can find a new ones that would be better thanks .
 

· Aquacraft
Joined
·
755 Posts
Discussion Starter · #3 ·
Brian Goodwin (or how ever you spell his name) up in Canada makes all new steering pulley setups. You may want to get a hold of him. He might be able to make you replacement pulleys or fix what you have. Or any good machinist should be able to fix them as well. I am not a machinist so I can’t help. I wish I was.

Paul
Thank you !, does Brain have a website or something? I wish you were a machinist also that way I can send you all my stuff :), I located two old ones but if I can get new or remade ones that would be great, and thank you for the help(y)
 
1 - 2 of 2 Posts
Top