Performance Boats Forum banner

1 - 10 of 10 Posts

·
Got Circus Midgets???
Joined
·
1,734 Posts
Discussion Starter #1
lookin to buy a new torque wrench, any recommendations?






.
 

·
Resident Ford Nut
Joined
·
10,075 Posts
I got this one so I can manipulate it around the headers and intake:





I stuck my head in a pawn shop the other day looking for a guitar for my son and there was one like it there (older version) for $ 140.00 :|err :)st

Sleeper CP
Big Inch Ford Lover :D
 

·
steelcomp was here
Joined
·
26,512 Posts
Any Craftsman, Mac or $nap-on click type is fine.
If you need anything more you should consider angle torquing.
IMO
X2
I have an inch/lb torque wrench made by the Utica Tool Co. Utica/Bonney...pricy little thing, but very nice. I'd like to see some of their bigger models. My SnapOn has been calibrated twice, and each time was still dead on. I have a Harbor Frieght that I use for lugnuts that's actually a decent torque wrenck. Go figure.:)sphss
 

·
Registered
Joined
·
43 Posts
I have a Snap On clicker,1/2 30-200, it doesent go low enough, the a 3/8 in pound on that goes up to 250in. I would buy a dial style next time, I never loan it out,afraid of the person droping it, going past the click or using it like a ratchet.


Isent the Craftsman a import?
 
1 - 10 of 10 Posts
Top