Performance Boats Forum banner

1 - 9 of 9 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter #1
I'm trying to find a product that you probably were used on earlier boats ( flat, tunnel,Bubble,and T decks) I'm looking for the wrap around windshield and wake shield that I've seen on these boats numerous times before but it seams like nobody's even making this boats any more so thinking you might have one or know of someone that would have more of these items on the back shelf or cold storage kidding although any help would be appreciated??/ Please advise Steve:)eh:)
 

·
Dead Member
Joined
·
230 Posts
I guess the bigger question is what type of boat are you hunting a windshield for? "PlasticMan" here on the forum makes them. I picked up a windshield from him for my Giroux TR2 and am very happy. As far as the Wake/backsplash guards go....the only people that make them are Finney's in Havasu, but they don't answer their phone!!!! So save a dime and don't bother with them. I've tried everyone mentioned here or listed on this forum. You'll have to make your own out of aluminum or go without.
 

·
Registered
Joined
·
6,918 Posts
I guess the bigger question is what type of boat are you hunting a windshield for? "PlasticMan" here on the forum makes them. I picked up a windshield from him for my Giroux TR2 and am very happy. As far as the Wake/backsplash guards go....the only people that make them are Finney's in Havasu, but they don't answer their phone!!!! So save a dime and don't bother with them. I've tried everyone mentioned here or listed on this forum. You'll have to make your own out of aluminum or go without.
Just make your splash template out of thick poster paper taped together for length. Go to any plastic shop and get 1/8" polycarbonate cut to your template. I did one using see through smoke polycarbonate and it was 73 bucks. 1/8" was easy to bend and fasten without heat. They round off the edges too. Looks and works great. BTW your new boat is awesome!
 

·
Registered
Joined
·
374 Posts
Not sure what you are looking for however, I have these that I am going to post for sale. I had them made for an older Daytona and never used them. They are new and I want $300 = the ride or I can take to Havasu. I think they were $550 when I had them made. Email directly if interested- [email protected]
 

·
Premium Member
Joined
·
185 Posts
finneys plastics and powder coating in lake havasu 928 680 6645 he has a lot of molds plus does great custom work
 

·
AKA OhOneWS6
Joined
·
2,637 Posts
Not sure what you are looking for however, I have these that I am going to post for sale. I had them made for an older Daytona and never used them. They are new and I want $300 = the ride or I can take to Havasu. I think they were $550 when I had them made. Email directly if interested- [email protected]
If those are the stock dimensions for a classic 21' Eliminator Daytona I am very interested. Second in line if the OP does not want them. Sent you an email.
 

·
Registered
Joined
·
4,318 Posts
X2 on Finnys....answers the phone (secretary) every time i call...early morning is better.....although he does get a little flaky around race time.
 
1 - 9 of 9 Posts
Top