Performance Boats Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
196 Posts
Discussion Starter #1 (Edited)
Want to buy cavitation plate hardware for V-bottom boat except for the plates. Need cross shaft(s) machined for the short levers, turnbuckles, short lever arms, actuation lever and through transom seals. Either one long shaft with staggered turnbuckles or two angled shafts and same length turnbuckles. Would also consider Hallcraft hex hardware. Race boat, not a show boat, does not need to be perfect.
Shirl Dickey
 

·
Registered
Joined
·
531 Posts
Want to buy cavitation plate hardware for V-bottom boat except for the plates. Need cross shaft(s) machined for the short levers, turnbuckles, short lever arms, actuation lever and through transom seals. Either one long shaft with staggered turnbuckles or two angled shafts and same length turnbuckles. Would also consider Hallcraft hex hardware. Race boat, not a show boat, does not need to be perfect.
Shirl Dickey[/QUOTE

I have several (6+) cross shafts (some with levers and different lengths) and pillow blocks. I don't have any turnbuckles, however. What length cross shaft will suit your purpose, how many pillow blocks, and how many turnbuckle levers on the cross shaft? Give me some info. and I'll check my stock. I can send photos!

Lynn (Pie) Youngs - located in Covina, Ca. - (626) 375-4286 (cell - voice only - no texts) or E-mail - [email protected].
 
1 - 3 of 3 Posts
Top